Tariffs Setup; Tariff Configuration And Resetting; Communication Setup And Test - KPS PowerCompact3020 Manual De Usuario

5.2.6. Tariffs setup.

5.2.6.1. Tarif configuration and resetting.
NOTE: avoid time of the different tariff bands to overlap. When the time of a tariff is changed, always make
sure that it does not overlap with the time of another tariff. To set 12:00 am, select 0:00.

5.2.7. Communication setup and test

Chose the tariff band to be set by selecting it with the cursor.
One selecting the tariff band, press
configuration and reset submenú.
This function resets the measurements previously performed (for
all 4 tariffs). The following options are available: NEVER - 1
MONTH - 2 MONTHS - 3 MONTHS
This page allows the user to set the following parameters for each
tariff:
start time (with 15 minute intervals)
end time (with 15 minute intervals)
access to the subpage to select the days on which the tariff is to
be applied
the cost of the kWh consumed (in the relevant currency)
the yield of the kWh generated (in the relevant currency)
return to the "Tariffs setup" page
This page allows the user to set the following parameters:
data transfer speed (baud rate): 4800, 9600, 19200, 38400,
57600, 115200 bps.
type of parity: No, Even, Odd.
protocol type: BCD or IEEE.
address of the instrument (which must be unique) if the latter
is connected to a PC with PowerCompact/Studio software.
press to Access the communication test page
- 70 -
to access the relevant