Installation - Wayne Dalton 9100 Instrucciones De Instalación Y Manual Del Propietario

Installation

IMPORTANT: READ INSTRUCTIONS TITLED "P4" "REMOVING THE OLD DOOR" ON PAGE 9 AND "P5" "PREPARING THE OPENING" ON
PAGE 10 BEFORE ATTEMPTING DOOR INSTALLATION.
IMPORTANT: STAINLESS STEEL OR PT2000 COATED LAG SCREWS MUST BE USED WHEN INSTALLING CENTER BEARING BRACKETS,
END BRACKETS, JAMB BRACKETS, OPERATOR MOUNTING/SUPPORT BRACKETS AND DISCONNECT BRACKETS ON TREATED LUMBER
(PRESERVATIVE-TREATED). STAINLESS STEEL LAG SCREWS ARE NOT NECESSARY WHEN INSTALLING PRODUCTS ON UN-TREATED
LUMBER.
NOTE: It is recommended that 5/16" x 1-5/8" lag screws be pilot drilled using a 3/16" drill bit, and 1/4" x 2" lag screws and
1/4" x 1-1/2" lag screws be pilot drilled using a 1/8" drill bit, prior to fastening.
1
Attaching Quick Install Flag
Angle to Vertical Track
Tools Needed:
NOTE: If you have fully adjustable
fl agangle, skip this step and complete
None
Step 2.
Place the lower quick install tab of the
fl agangle in the quick install feature of
the vertical track. Give the fl agangle 1/4
turn to lock in place. Repeat for other
side.
NOTE: After completing this step,
continue with Step 3.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
QUICK INSTALL TAB UNLOCKED
FLAGANGLE
VERTICAL
TRACK
LEFT HAND TRACK AND FLAGANGLE
QUICK INSTALL TAB LOCKED
FLAGANGLE
VERTICAL
TRACK
RIGHT HAND TRACK AND FLAGANGLE
11