Wayne Dalton 9100 Instrucciones De Instalación Y Manual Del Propietario página 6

P1
Torsion Spring Removal
Tools Needed:
WARNING
FAILURE TO USE APPROVED
Approved
Winding Bars WINDING BARS CAN CAUSE
SPRING ENERGY TO BE RELEASED
SUDDENLY, RESULTING IN SEVERE
3/8" Wrench
OR FATAL INJURY.
WARNING
Vice Clamp
COUNTERBALANCE SPRING
TENSION MUST BE RELIEVED
Recommended BEFORE REMOVING ANY
tools from
HARDWARE. A POWERFUL
page 5
SPRING RELEASING IT'S ENERGY
SUDDENLY CAN CAUSE SEVERE OR
FATAL INJURY.
Do not release the torsion spring tension
unless you are qualifi ed and experienced
door technician, but have a professional
door agency release the tension.
Step 1: Close the door and place vice
clamps to the back legs on both vertical
tracks, above the third roller to prevent
the door from lifting as you unwind the
springs. Use only approved winding bars
available from your dealer. Do not use
undersized steel rods, screw drivers or
anything else to unwind the springs.
Position the ladder just off to the side
of the winding cone. The winding cone
should be easy to reach without putting
your body directly in front of it.
Step 2: Insert a winding bar into one
of the holes in the winding cone. Exert
upward pressure. Using caution, loosen
the two (2) set screws in the winding
cone. Be prepared to support the full
torsional force of the spring when the set
screws are loosened.
Step 3: Once set screws are loose, slowly
and carefully lower the winding rod until it
rests against the door. Insert other winding
bar into the upper hole. Push up and
remove lower bar. Carefully lower upper
winding bar until it rests against the door.
Repeat process until all tension is relieved.
If your door is equipped with two (2)
torsion springs, follow the same procedure
to relieve tension on the second spring.
Step 4: Remove vice clamps from tracks,
unbolt torsion shaft assembly and remove
from work area.
NOTE: Continue with "P4" on page 9 after
completing this step.
6
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
For Standard Lift
TORSION ASSEMBLY
APPROVED WINDING BAR
WINDING CONE
SET SCREWS
FIRMLY HOLD WINDING BARS AND
CAUTIOUSLY LOOSEN SET SCREWS