Wayne Dalton 9100 Instrucciones De Instalación Y Manual Del Propietario página 28

29
Tools Needed:
Vice Clamp
FAILURE TO PLACE VICE
CLAMPS ONTO VERTICAL TRACK
CAN ALLOW DOOR TO RAISE
AND CAUSE SEVERE OR FATAL
INJURY.
Place vice clamps onto both vertical
tracks just above the third roller. This is
to prevent the garage door from raising
while winding counterbalance springs.
IMPORTANT: DO NOT USE IMPACT GUN
TO WIND SPRING(S).
30
Tools Needed:
Rotate the cable drum until the set
screw faces directly away from the
Locking Pliers
header. TorqueMaster
Flat Tip
peak should be pointing straight up.
Screwdriver
Beginning with the right side, loosen
the set screw enough to adjust cable,
approximately 2 turns. Using locking
pliers, pull on the end of the cable to
remove all cable slack.
Check to ensure the cable is aligned
and seated in the first groove of the
cable drum. Snug the set screw, then
tighten an additional 1-1/2 turns. Cut
excess cable.
28
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
Securing Door
for Spring Winding
WARNING
Cable Adjustments
® spring tube cam
COUNTERBALANCE
CABLE
CABLE
DRUM
CAM PEAK
STRAIGHT UP
PLACE VICE
CLAMPS ABOVE
3RD ROLLER
VICE CLAMPS
TRACK
ATTACHED TO
INNER RAIL
OF TRACK
SET SCREW