Reset Defaults (Pontos Service Only) - Pontos AquaCycle 2500 Instrucciones De Montaje

P11 water meters
Only the meters set under the "Settings /
Parameter / General / Configuration" are
displayed.
• P110 meter-TWN
o Setting the drinking water meter
(litres/pulse)
• P111 meter-BW
Setting the drinking water meter (litres/pulse)
P12 min. currents
• P120 I-min. UV
o Minimum current intensity UV (Amps)
• P121 I-min. V1
o Minimum current intensity, air pump
V1 (Amps)
• P122 I-min. V2
o Minimum current intensity, air pump
V2 (Amps)
• P123 I-min. P1
o Minimum current intensity,
submersible pump P1 (Amps)
• P124 I-min. P2
o Minimum current intensity,
submersible pump P2 (Amps)
EN 38
Operating Manual AquaCycle 2500
6.9.2. Reset defaults (Pontos
Service only)
If a new software status is imported to the
controller, the parameters only change if the
values are reset manually.
Coming from the main page of the controller:
Acknowledge
Select
Acknowledge
The password is: *******
Increment
Select numbers
Acknowledge
Selection
Acknowledge
Acknowledge
Version 2.5