Technical Data - Pontos AquaCycle 2500 Instrucciones De Montaje

11. Technical data

Weight
Weight of system empty
Weight of tanks empty
System in operation
Connections
Drinking water connection
Rainwater connection**
Process water connection for filter
backflush
Process water connection
Infeed into the system***
Overflow into sewer
Aeration and ventilation
The installation room must be sufficiently aerated and have a floor drain
Capacity
Working capacity, Stage 1-3
Maximum flow rate, operating pressure
and start-up pressure, process water
Mains connection
Mains
Mains connecting cable
Maximum power consumption:
Fusing (customer's back-up fuse)
Current consumption
Capacity
Pressure booster system
Electric ball valves
Solenoid valve, filter backflush
Solenoid valves, feed
Submersible pumps P1
Submersible pumps P2
UV disinfection
Aeration (air blower LA 80)
Max. total power
Ambient temperature
Relative humidity
* In the case of charging with a pumping system, this must be restricted to max. 100l/min. An emergency overflow must be
provided for the pumping system.
** The quality of the fed-in rainwater must be in line with the quality as stated in the Fachvereinigung Betriebs- und
Regenwassernutzung e.V. (fbr) Information Sheet H201. Otherwise, Pontos cannot accept any responsibility for the quality of
the process water.
*** Only waste water from showers and bathtubs may be fed into the grey water treatment system.
Version 2.5
600 kg
120 kg each, total 360 kg
3.000 kg
¾˝ thread;
max. 0.4 MPa flow pressure; max. 1.0 MPa static pressure;
maximum necessary flow rate to be provided by customer
½˝ thread;
max. 0.3 MPa flow pressure, max. 1.0 MPa static pressure;
to be protected with pressure reducer
2" thread
DN 100 – to be vented separately over roof*
DN 100 – Safeguard with odour trap to the sewer!
DN 70
800 litres each
Dependent on the pressure booster system provided by the
customer
230 V 50 Hz TN-S (L, N, PE) safety plug
H05RN-F3G 1.5mm²; l=5m; safety plug IP44
DIN VDE 0620 (2010)
2.0 A
16 A
2.5 kWh/day
(without customer's pressure booster system)
See pressure booster system documentation
4 W each; total 12 W
8.5 W
8.5 W each; total 17 W
78 W
35 W
36 W
86 W each; total 172 W
0.4 kW
12 ° C to 35 °C
max. 95 %
Subject to technical modifications and errors.
Operating Manual AquaCycle 2500
EN 65