Measures Required During The Shutdown Period; Restarting The Vehicle After Shutdown - Jungheinrich ETR 314 Manual De Instrucciones

NOTICE In addition, all instructions of the battery manufacturer must be followed.
– Spray all exposed electrical contacts with a suitable contact spray.
7.2

Measures required during the shutdown period

Every two months:
– Charge the battery (see "Charging the battery" in Chapter F).
IMPORTANT Battery-operated industrial trucks:
Regular charging of the battery is very important; otherwise spontaneous
discharge could lead to total discharge of the battery. This would result in
battery failure due to sulfation.
7.3

Restarting the vehicle after shutdown

– Clean the truck thoroughly.
– Lubricate the industrial truck according to the lubrication plan
(see "Lubrication plan" in Chapter G).
– Clean the battery. Grease the pole screws with pole grease and reconnect the
battery.
– Charge the battery (see "Charging the battery" in Chapter F).
– Check whether there is condensation water in the gearbox oil and replace it if
necessary.
– Check whether there is condensation water in the hydraulic oil and replace it if
necessary.
– Start the industrial truck
(see "Starting the vehicle" in Chapter E).
IMPORTANT Battery-operated industrial trucks:
In the event of contact problems in the electrical system, spray the exposed
contacts with contact spray and operate the controls repeatedly to remove
any oxide film on the control contacts.
Qw W
Test the brakes several times immediately after starting up the vehicle.
G 17