Parameter Settings - Jungheinrich ETR 314 Manual De Instrucciones

1.4.3 Parameter settings

To change the vehicle settings you must enter the master code.
NOTICE The master code is factory set to 7-2-9-5.
IMPORTANT When the vehicle is used for the first time, change the master code.
To enter the master code:
– Press the o key
– Enter the master code.
Code lock parameters
Setting process for vehicles:
– Enter the three-digit parameter number and press the Set key (56) to confirm.
– Enter or change the setting as shown in the parameter list and press the Set key
(56) to confirm.
If an illegal value is entered, the LED (55) in the o key (61) flashes red. Enter
NOTICE
the parameter number again and then enter or change the setting.
Repeat the process to enter additional parameter settings. When you have finished,
press the o key (61).
E 23