Picking Up, Lifting, And Transporting Load Units; Switching Off And Securing The Vehicle - Jungheinrich ETR 314 Manual De Instrucciones

3.10

Picking up, lifting, and transporting load units

– Bring fork tines horizontal.
– Drive up to the load unit
Shift fork carrier forward.
– Raise tines to the correct height.
– Drive the tines under the load unit.
– Lift up the load unit.
– Retract fork carrier.
Qw W
Transport runs with and without
a load should be made only with
the fork carrier retracted and
tilted backward and the load
pick-up lowered.
– Lower the load unit into the transport position.
– Tilt the load unit backwards.
– Transport the load unit.
– Bring the load unit into the horizontal position.
– Bring load unit to the correct height.
– Set down the load unit.
– Retract pantograph.
3.11

Switching off and securing the vehicle

When the vehicle is left, even for a short time, it must be switched off and secured.
Qw W
Do not park the vehicle on a slope. The load carrier must always be lowered
completely.
– Use the brake key (26) to engage the
parking brake.
– Lower the load carrier completely and
make sure it is horizontal.
– Completely retract fork carrier.
– Press the EMERGENCY OFF (13)
switch to the "Off" position.
– Switch the switch latch (4) into the "0"
position, remove the key or for code lock
press the o key.
E 40
V
R
S
U
25
26 4 13
24
T
H