Storage When Not In Use; Troubleshooting; If There Is A Jam In The Appliance; If The Appliance Suddenly Stops Working - UNITED OFFICE UAVS 300 A1 Instrucciones De Uso E Indicaciones De Seguridad

♦ Remove any residue left in the cutting openings
with a suitable object (e.g. brush or tweezers). Ensure that the appliance is
unplugged before doing this.
♦ Clean the surfaces of the appliance with a soft, dry cloth.
♦ Use a lightly moistened cloth and a mild detergent to remove stubborn dirt
residues from the appliance surface.

Storage when not in use

♦ If you decide not to use the appliance for a long period, disconnect it from
the mains power supply and store it in a clean, dry place away from direct
sunlight.

Troubleshooting

If there is a jam in the appliance

This means that you may have attempted to feed too much paper into the appli-
ance (max. 10 sheets 80 g/m
♦ Move the REV/OFF/AUTO/FWD switch
causes a blockage. The appliance now goes into reverse and the material is
ejected.
♦ Alternatively, move the REV/OFF/AUTO/FWD switch
position if the paper causes a blockage. The appliance is now in forwards
operation and the material that is being shredded is pulled in again.
♦ Pull the paper out of the appliance and then move the REV/OFF/AUTO/
FWD switch
The appliance is now ready for use again.

If the appliance suddenly stops working

This means that the appliance has overheated and the automatic safety cut-out
has activated itself. The overheat lamp
Move the REV/OFF/AUTO/FWD switch
♦
♦ Remove the plug from the mains power socket.
♦ Allow the appliance to cool down for about 30 minutes.
♦ Replace the plug in the mains power socket.
Switch the appliance on by moving the REV/OFF/AUTO/FWD switch
♦
to the AUTO position. The power lamp
The overheat lamp
sufficiently.
GB │ IE
│
■ 12
2
paper).
8
to AUTO.
7
remains off when the appliance has cooled down
2 9
/ or cutting blades
8
to the REV position if the paper
8
7
lights up permanently red.
8
to the OFF position.
6
lights up permanently blue.
to the FWD
8
UAVS 300 A1