Technical Data - Xylem Lowara ResiBoost MMW Manual De Instalación, Funcionamiento, Mantenimiento

Example: ResiBoost MMW09DE
ResiBoost
M
M
W
09
DE
...

3.3 Technical data

Table 11: MMW and MTW standard versions
Converter mod- MMW09...
el
Rated voltage 1x230V (-20% – +10%)
input (Uin)
Rated voltage 1x(0–100%)Uin 3x(0–100%)Uin
output (Uout)
Rated input fre-
quency
Output frequen-
cy
Rated input cur- 9,5A
rent
(Uin-230V)
8
The current supplied by the converter shall not be lower than current absorbed by the electric pump and cable, if this is
very long.
9
Choose the current of the line protection device in relation to the maximum current absorbed by the motor. The value in
the table refers to the full load condition.
10
For higher altitudes or other environmental conditions not covered in this manual, contact service.
Serial name of the con-
verter
Mains power supply
M: single-phase
1x230Vac
Pump motor power sup-
ply
M: single-phase
1x230Vac
T: three-phase
3x230Vac
W: Converter installed on
the delivery line of the
pump and cooled with
water.
A: Wall-mounted con-
verter cooled with air.
Nominal current supplied
by the converter.
Available in the following
sizes, depending on type
(refer to the technical da-
ta): 06A, 09A, 10A, 12A.
Type of plug of converter
power supply cable
DE: European Schüko
UK: British
AU: Australian
C: without plug
EMC class = C1 (EN
61800-3) ≈ B (EN 55011)
(A1) = C2 (EN 61800-3)
≈ A1 (EN 55011)
MTW10...
50/60±2 Hz
15–70 Hz
18A
Rated output
8
current
(Uout=230V)
Overcurrent 20%, 10 second maximum
Recommended 13A
9
line protection
Consumption in
standby
Type of load
Nominal cosφ ≥ 0,60
(motor)
IP protection
Maximum pow-
er cable section
Maximum motor
power cable
section
Set-point pres- 0,5–8 bar (50–800 kPa)
sure
Maximum pres-
sure (PN)
Water flow rate
Ambient tem-
perature
Maximum water
temperature
Ambient humidi- < 50%, non-condensing
ty
Pumped liquid Water that is free of aggressive
chemical substances and sus-
pended solids. Not suitable for
10
Elevation
Protection fuse 16A
(inside)
Digital input for
float switch con-
tact
Dimensions and See
weight
Table 12: MMA and MTA standard versions
Converter mod- MMA
el
06...
Rated voltage 1x230V (-20% – +10%)
input (Uin)
Rated voltage 1x(0–100%)Uin 3x(0–100%)Uin
output (Uout)
en - Original instructions
9A 10A
25A
4W
electric motor
≥ 0,75
55
2
2,5 mm
2
2,5 mm
15 bar (1500 kPa)
0,5–250 l/min
0–50°C (32–122°F)
40°C (104°F)
contact with glycol.
≤2000m asl
20A
24Vdc, 23,9mA
on page 250.
Figure 3
MMA MTA MTA
12... 06... 10...
27