Components For Correct Installations With Submerged Electric Pumps; Electrical Installation - Xylem Lowara ResiBoost MMW Manual De Instalación, Funcionamiento, Mantenimiento

en - Original instructions
Number Component
7 Non-return
valve with filter
(foot valve)
8 Pressure gauge
9 Pressure trans-
ducer
10 Non-return
valve
11 Gate valve
12 Diaphragm
tank, minimum
8 liters
13 Converter
14 Converter pow-
er panel
15 Power panel
with high sensi-
tivity differential
switch (30 mA).
See Electrical
requirements
page 28.
16 Storage tank
17 Float switch
18 Filter for motor
cable over 30 m
in length.
4.3.3 Components for correct installations
with submerged electric pumps
See Figure 26 on page 267,
Figure 28 on page 269, and
Number Component
1 Electric pump
2 Cable clamp
3 Motor power ca-
ble
4 Level probes to
prevent dry run-
ning (or other
level control
sensor)
5 Mounting brack-
et
6 Non-return
valve
7 Pressure gauge
8 Pressure trans-
ducer
9 Gate valve
30
Included in the
kit
√
√
√
on
Figure 27 on page 268,
Figure 29 on page 270.
Included in the
kit
√
√
√
√
Number Component
10 Diaphragm
tank, minimum
8 liters
11 QCL5 control
board for level
probes
12 Filter for motor
cable over 30 m
in length.
13 Converter
14 Converter pow-
er panel
15 Delivery pipe
16 Electric pump
bleed / priming
cap
17 PTC or PT1000
(available only
with some mod-
els of the sub-
merged motor)
18 Power panel
with high sensi-
tivity differential
switch (30 mA).
See Electrical
requirements
page 28.
19 Quick coupling
(provided for
fastening the
converter on the
pump)
The following notes and recommendations refer to
Figure 26 on page 267, Figure 27
ure 28 on page 269, and
A. Distance between the clamps that secure the
drop cable to the delivery pipe.
B. Distance from the bottom of the well to the elec-
tric pump.
Recommendations:
• Non-return valve at 10 m distance from the deliv-
ery flange, plus an additional non-return valve
every 30-50 m of piping.
• Secure the drop cable to the pipe every 2 to 3
metres of piping.
• Make sure the electric pump is installed at a safe
distance from the bottom of the well.
• Make sure there is a minimum distance of 3 mm
between the diameter of the pump and the inter-
nal diameter of the well.
• During operation, make sure that the water circu-
lation speed around the motor is at least 8 cm/
sec.
• Make sure that the minimum dynamic level of the
water in the well is at least 1 m above the pump's
delivery flange.

4.4 Electrical installation

Included in the
kit
√
on
√
on page 268, Fig-
Figure 29 on page 270.