General Information; Introduction; General Service Policy; Safety Information - Cebora 337 Manual De Servicio

CEBORA S.p.A.

1 GENERAL INFORMATION

1.1 Introduction

The purpose of this manual is to train the personnel in charge of maintaining the
Power source art. 337 for plasma cutting systems.

1.2 General service policy

It is the responsibility of the customer and/or operator to use the equipment
appropriately, in accordance with the instructions in the Manual, as well as to maintain
the equipment and related accessories in good working condition, in compliance with
the instructions provided in the Service Manual.
Any internal inspection or repair must be carried out by qualified personnel who are
responsible for any intervention on the equipment.
It is forbidden to attempt to repair damaged electronic boards or modules.
Replace damaged parts with original Cebora spare parts only.

1.3 Safety information

The safety notes provided in this manual are an integral part of those given in the
Instruction Manual. Therefore, before working on the machine, please read the
paragraph on safety instructions in the aforementioned manual.
Always disconnect the power cord from the mains, and wait (at least 1 minute) for
the internal capacitors to discharge before accessing the interior of the equipment.
Some internal parts, such as terminals and dissipaters, may be connected to mains
or otherwise hazardous potentials. It is therefore forbidden to work with the safety
guards removed from the machine unless strictly necessary. In this case, take special
precautions such as wearing insulating gloves and footwear, and working in a perfectly
dry environment with dry clothing.

1.4 Electromagnetic compatibility

Please read
"Electromagnetic compatibility" of the Instruction Manual.
3302336-B
and observe the instructions provided
43
in the paragraph
20/12/2019