ARIETE Gran Gelato metal 693 Manual De Instrucciones página 12

EN
IMPORTANT: It is not necessary to chill the container in a freezer because this ice cream maker has
an internal compressor that will chill the ingredients to make the ice cream.
APPLIANCE ASSEMBLY
WARNING: ALWAYS UNPLUG THE POWER CORD FROM THE ELECTRICITY MAINS BEFORE
FITTING OR REMOVING SINGLE ATTACHMENTS OR BEFORE CLEANING THE APPLIANCE.
IMPORTANT: Always use the ice cream maker upright and on a flat surface to get the best from the
compressor.
- Insert the removable container (D) into the fixed one (C) inside the machine (Fig. 2).
- Place the mixing paddle (E) inside the removable container (D) (Fig. 3).
- Fit the lid (F) onto the appliance body, holding the mixing paddle (E) in the upright position in the
centre of the lid and locking it in place by turning it clockwise so that the tabs on the power base
slot into the openings on the lid (Fig. 4).
- Close the opening for inserting ingredients with the special cap (G) (Fig. 5).
- Fit the power unit (H) onto the lid (F) and make sure that the motor axle has been inserted properly
into the hole on the top part of the mixing paddle (Fig. 6).
INSTRUCTIONS FOR USE
IMPORTANT: Before starting the ice cream maker, make sure that it has been perfectly assembled
and the power unit has been firmly attached to the lid.
- Plug the appliance into a mains power socket. Press the power button (P) to supply power to the
appliance; the display (L) will show"60.00" meaning that the default operating time is 60 minutes.
- Based on the recipe, press the Timer button (N) to set the operating time: press the button repeat-
edly until the required time (10, 20, 30, 40, 50, and 60 minutes) is shown on the display (L).
- Pour the previously prepared mixture in through the opening in the lid (F) (Fig. 6).
IMPORTANT: To avoid excessive volumes or waste, make sure that the ingredients never exceed
80% of the capacity of the removable container (D). Remember that ice cream increases in volume
while it is being made.
- At this point, press the start button (O) to start up the appliance and it will start to prepare ice
cream. At the same time, the mixing process will commence with the mixing paddle (E), together
with the chilling process, via the internal compressor and both LEDs (I-M) will switch on.
- When the power button (P) is pressed during the ice cream making process, the appliance will
immediately commence a countdown of three minutes, after which the machine will start up again;
the chilling and mixing functions will start up together. If, while counting down, the power button
(P) is pressed again, the mixing function will commence immediately while the chilling function will
only commence after the countdown.
IMPORTANT: If there is a power blackout or the appliance is suddenly disconnected while making
ice cream, there will be no automatic countdown function. We recommend starting the machine after
3 minutes, otherwise it will pass into compressor auto-protection mode.
- When the two processes have been completed and the ice cream is ready, the appliance will stop
automatically and an acoustic warning will sound 10 times. The display (L) will read "00.00" to
show the end of the countdown.
IMPORTANT: Never remove the power unit (H) while the ice cream is being made.
- 10 -