Configuring Via The Web Interface - Mennekes AMEDIO Proffesional+PnC 22 T2S Manual De Instrucciones Y De Instalación

6.2 Configuring via the web interface

Configuration occurs via the web interface in a web
browser. The web interface is password-protected.
Both charge points in the device are pre-config-
ured as a master/slave connection (for OCPP).
„ Perform configuration tasks only via the mas-
ter web interface. Most of the settings are
automatically adopted for the slave charge
point or they are not relevant to the slave
charge point.
„ The settings that need to be made separately
via the slave web interface are shown in the
table under "Comments".
Î "6.2.6 Advanced settings"
f To this end, open the web interface of the
slave ECU.
Î "Fig. 21: Selection page: Master - Slave"
Via USB
9
Requirement: The connection to the ECU is set up via
USB.
Î "6.1 Setting up a connection to the ECU"
f Open the web browser.
The web interface can be reached via
http://192.168.123.123/operator.
Via Ethernet
9
Requirement: The connection to the ECU is set up via
Ethernet.
Î "6.1 Setting up a connection to the ECU"
f Open the web browser.
The web interface can be reached via
http://192.168.124.123/operator.
20
9
A selection page opens where you can choose wheth-
er to configure the master ECU or the slave ECU.
1
Fig. 21: Selection page: Master - Slave
f Open the web interface of the master ECU (1).
f Enter password.

Password: See Setup data sheet.
f Configure the device taking into account the local con-
ditions and customer requirements.
f Save the configuration that has been made by clicking
the "Save" button.
f When the configuration is concluded, click the "Save &
Restart" button.
The web interface offers some setting options
that are not supported by the device.
In the section "3 Product description".>
"Equipment features" there is an overview of the
device functions.