Mennekes AMEDIO Proffesional+PnC 22 T2S Manual De Instrucciones Y De Instalación página 72

RFID Tag letter case Setting that specifies how the RFID-
UIDs will be processed by the tag
management
Send Authorize for Setting that specifies whether after
RemoteStart receipt of an OCPP RemoteStart
request, an OCPP authoriza-
tion message will be sent to the
Backend-System
Stop Transaction Setting that specifies how the
Mode device should behave at the end of
a transaction
Restart transaction Setting that specifies whether a
after power loss transaction will be continued after a
power outage
Send informative Setting that specifies whether infor-
StatusNotifications mative OCPP status messages will
be sent to the Backend-System
Send error Setting that specifies whether error-
StatusNotifications related OCPP status messages will
be sent to the Backend-System
Send USB error
StatusNotification
Strategy for Setting that specifies the conditions
StatusNotification under which the charging point
state transitions changes to the "Occupied" state
Preparing until state Setting that specifies the conditions
C (OCPP 1.6) under which the charging point
changes to the "Charging" state
Allow long get confi- Setting that specifies whether OCPP
guration keys keys are allowed to contain more
than 500 characters
28
Authori-
zation
Information will be provided from your
Backend-System operator
Backend-
System
"Stop only by unplugging": Used to ter-
minate the transaction only if the plug is
disconnected from the charging station
Charging
system
For example, temperature reports
Backend-
System
Not relevant for the device
„ Only for "OCPP-S 1.5"
„ "Occupied on Charging": Occupied
when an authorization is present and a
charging cable is plugged in
„ "Occupied on Authorized/Plugged":
Occupied when the charging point is
authorized or a charging cable / vehicle
is connected
Backend-
„ Only for "OCPP-S 1.6" and "OCPP-J 1.6"
System
„ "On": Charging when the vehicle is in C
status
„ "Off": Charging when the vehicle is in
status B or C