Block 5: USB network
Parameter
Static USB network configura-
tion additional IP
Static USB network configura-
tion gateway
Static USB network configura-
tion DNS
Block 6: Backend-System, network
Parameter
Public address of the
ChargePoint
Mode for selecting the public
address of the ChargePoint
WAN router password
SSL Strictness as client
SOAP OCPP Server Port of
ChargePoint (Standard OCPP)
SSL mode as server
Backend connection timeout
Display backend disconnect
as error
Block 7: Authorization, Backend-System
Parameter
Description
OCPP mode
Selection of the OCPP communica-
tion protocol
SOAP OCPP URL of
URL address of the Backend-System
backend (standard
OCPP)
Backend Whitelist
List of the IP addresses that are allo-
(SOAP)
wed to send requests to the device
26
Description
Additional, fixed IP address for group-
ing of USB network
Description
Public IP address of the ChargePoint
Mode for the selection type of the public IP
addresses of the charging point
Password for access to WAN router
SSL authentication as client
TCP server port for the incoming connections
from the Backend-System
SSL function and authentication as server
Time until an error message is displayed,
after the connection to the Backend-System
has been interrupted or could not be resto-
red
Setting that specifies, whether the error
"Backend disconnected" will be displayed.
Necessary for ...
Charging system
Not relevant for the device
Not relevant for the device
Necessary
for ...
Backend-
System
Network
Backend-
System
Charging
system
Necessary
Remark
for ...
Information will be provided by your
Backend-System provider
Backend-
Information will be provided by your
System
Backend-System provider
Only for "OCPP-S 1.5" and "OCPP-S 1.6"
Remark
The setting has to be
"192.168.125.124"
Remark
Information will be pro-
vided by your Backend-
System provider
Only relevant, if "Display
backend disconnect as
error" = "On"
If this error is displayed
the "Fault" LED on the
device is flashing