Publicidad
Idiomas disponibles
Idiomas disponibles
4.4.1.3.3 Balance Reading Measuring Mode
It is another measuring mode. Firstly set balance condition (please refer to system setup chapter
for detailed operation). When measurement starts, meter will automatically measure, calculate
and display measuring result. As soon as the measuring meets the balance condition set,
measurement finishes.
During measurement, user could view measuring parameter, calibrate electrode etc... When
measurement finishes, user could store, print measuring result and press 'X' (quit) on upper right
corner to exit the measuring mode or to start next measuring by pressing 'CONT'.
4.4.2 Set Ion Mode
It is designed mainly for easy use. Meter provides about 10 general kinds of ion mode in
correspondence with different ion measurements and user could select relevant ion mode to make
concentration measurement. When concentration measurement finishes, user could view current
ion concentration value according to different ion concentration unit.
Press 'SETUP' button, select 'Ion mode' and then press 'ENTER' to enter into 'set ion mode' part
which is shown as follows:
Meter divides ion into four valences: one-valence ion mode, two-valence ion mode, three-valence
ion mode and custom ion mode. Meter provides some general ion modes. One-valence ion
(including one-valence cation, one-valence anion) has 10 kinds. They are: H
-
-
-
-
Cl
, F
, NO
, BF
, CN
3
4
Two-valence ion is three kinds of cation: Cu
-
+
, etc...(because H
is always allowed, it is not displayed in 'Set Ion Mode').
2+
Display
chart
measuring mode
Display chart of 'Set Ion Mode'
2+
2+.
, Pb
, Ca
On the right side of screen, there is a
of
'Balance
Reading'
+
+
+
+
, Ag
, Na
, K
, NH
+
,
4
64
Publicidad
