SATA AE1017H Instrucciones De Uso página 50

Chapter V Operation
The valve shall be placed on the right side of the tire-changing mount/dismount head with a gap of 10 cm to
avoid damage to the inner tube (Fig. 5-5).
If the clamping jaw is in an open position when the tire is pressing, the operator's hands are exposed to high
risks. Never put your hands in contact with the tire wall during the tire pressing process.
It is advisable to use a pressure regulator for the tire changer.
Apply the supplied lubricating grease (or similar lubricating grease) to the tire edge. Such grease shall be non-
toxic, non-flammable and harmless or else the tire edge may sustain serious damage.
Be sure to use the machine only after you have read and understood the entire manual and warnings. Before
operation, deflate the tire and remove all lead weights from the wheel.
The operation of the tire changer includes: a) tire pressing; b) tire changing; and c) tire mounting.
5. 1 Tire pressing
Be extremely careful when conducting the tire-pressing operation. When the tire-pressing foot pedal is driving
the tire-pressing arm to move quickly, the arm may endanger everything in the radius of its movement.
Check if the tire is deflated. If not, discharge the air from inside the tire. Completely close the clamping claw of the large plate.
50
AE1017H
中文
EN DE RU
Place the wheel against the rubber on the right side of
the tire changer cabinet (Fig. 5-1 M). As shown in Fig.
5-2, place the tire-pressing shovel (Fig. 5-1 N) about 1 cm
from the tire edge. Note: the tire-pressing shovel shall
be placed against the tire rather than against the rim.
Fig. 5-1
KO PT JA ES