SATA AE1017H Instrucciones De Uso página 59

Chapter VI Inflation
As the tire changer is not specially designed and manufactured to protect the people around in case of sudden
explosions, extreme care shall be taken when the tire is inflated, and the instructions below shall be strictly
followed.
A sudden explosion may cause the operator serious injury or even death. Carefully check and make sure that rim and the tire are the
same size. Confirm that the tire is free of defects or wear before inflation. Check the pressure after each jet of air. The maximum
inflation pressure applies to all of our tire changers (3.5 bar = 51 psi). The pressure values recommended by the manufacturer shall not
be exceeded. Keep your body and hands as far away from the tire as possible.
6.1 Inflate the tire while checking the inflation indicator
According to the standard version, our tire changers is equipped with an inflation indicator. The inflation procedure is as follows:
Warning: There is a risk of explosion.
The tire inflating pressure shall not be more than 3.5 bar (51 psi). If higher pressure is required, remove the
tire from the large plate and inflate it in the special protective cage. Do not exceed the inflating pressure
recommended by the manufacturer, and keep your hands and other body parts behind the tire during inflation.
The inflation procedure shall only be conducted by specially trained and authorized personnel. Other personnel
shall not work or stand near the tire changer.
AE1017H
中文
EN DE
① Connect the inflation indicator to the tire valve.
② Check the dimensional fit between the tire and the rim.
③ Check if the tire edge is fully lubricated and perform
further lubrication if necessary.
④ Inflate the tire and check the readings of the inflation
indicator.
⑤ Check the air pressure while inflating the tire.
RU KO PT JA ES
59