Tabla de contenido
Publicidad
ASSEMBLY
Raising the arm:
1.
The springs in the arm are powerful so place your hand on top of the arm to control its movement.
2.
Turn the arm lock lever to the Uposition and hold it there. The arm will rise.
Lowering the arm:
1.
Turn the arm lock lever to the Uposition and hold it there.
2.
Press the arm down and, while holding it there, release the arm lock lever.
Fitting the bowl
Raise the arm before fitting or removing the bowl. Use only the bowl supplied.
1.
Fit the bowl into the recess in the base and turn it clockwise until it locks.
2.
To remove, turn it anti-clockwise then lift it off the base.
Fitting/removing attachments
Switch off, unplug and raise the arm before fitting or removing attachments.
1.
Align the slot in the attachment with the pin on the drive shaft (Fig A).
2.
Push the attachment onto the drive shaft then turn it anti-clockwise to lock it (Fig B).
To remove an attachment, push it upwards slightly then turn it clockwise and pull it off the shaft.
Splash guard
The splash guard protects you from spills or splashes during mixing while still allowing you to add
ingredients. Switch off and unplug your mixer before fitting/removing the splash guard.
With the bowl in position and the arm in the lowered position:
1.
Slide the splash guard between the arm and the bowl.
2.
Align it so that the opening is on the right hand side (Fig C).
•
Always remove the splash guard before raising the arm.
USING YOUR MIXER
Check that the speed control is set to O.
1.
2.
Put the plug into the power socket (switch the socket on, if its switchable).
3.
Turn the speed control clockwise to the speed you want.
The range is from 1 (low) to 10 (high). Turn the speed control back to O to turn the motor off.
4.
5.
To operate the motor in short bursts, turn the speed control to the Y position. Release the control to
stop the motor.
Recommended Speeds
Attachment
Speed
Whisk
7-10
Beater
Dough hook
ASSEMBLY
1.
Slide off the blending jug drive cover (Fig D).
2.
Insert the jug into the drive opening with the t mark on the jug aligned with the Umark on the
mixer (Fig E).
3.
Twist the jug clockwise until the t mark on the jug is aligned with the Lmark on the mixer (Fig F).
Add the ingredients to the jug and fit the lid and cap (Fig G). Don't fill past the max mark on the jug.
Never use the jug without the lid fitted.
FOOD MIXER
Use for
beating/aerating cream, egg whites, batter, light mixes
4-7
creaming butter and sugar, medium cake mixes
1-3
heavy mixtures, bread, pastry
BLENDER
5
GB
DE
FR
NL
IT
ES
PT
DK
SE
NO
FI
RU
CZ
SK
PL
HR
SI
GR
HU
TR
RO
BG
AE
Publicidad
Tabla de contenido
