To Release Program Lock; Beep Tone - Panasonic NE-1880 Manual De Instrucciones

X To Release Program Lock:
PAD
1
Keep the door closed.
Digital Display Window must be blank.
2
Press Program Lock Switch until "PROG" and "P" appear.
(for five seconds)
"PROG" and "P " will appear.
PROG LOCK
In Program Unlock mode:
• Oven reverts to a two-touch operating mode (Memory pad + Start pad).
• Repeat and interrupt feature are operational.
• Memory pads can be programmed.
• Tone loudness control and length control are operational.
E. BEEP TONE
The loudness of beep tone and the length of beep tone at the end of heating cycle can be set.
There are four levels of the loudness.
There are two options of the length of beep tone at the end of heating cycle.
The loudest level and 3 beeps are preset at the factory.
X To Select Loudness Level and Length "3 beeps":
PAD
1
Press Program Entry Switch.
"PROG" sign will start to blink in the display window. (The door may
be open or closed at this stage)
PROG
2
Press Buzzer Switch.
The tone will sound at its loudness level and the loudness level "3"
followed by the word "bEEP" will appear. "PROG" will start to blink
and 1st Stage Heating Indicator "1" (the length of beep tone
"3 beeps") will be indicated.
BUZZ
Note: Repeating to press Buzzer Switch will lower the loudness level
3
Press Program Entry Switch again.
"PROG" will stop blinking. That means that you have completed
program.
Three seconds later, the display window will go blank when the
PROG
door is closed.
How to Operate NE-1880
INSTRUCTION
INSTRUCTION
all the way to silent. (3bEEP –– loudest, 2bEEP –– middle,
1bEEP –– quietest, and 0bEEP –– silent)
- 23 -
DIGITAL DISPLAY WINDOW
PROG
DIGITAL DISPLAY WINDOW
PROG
PROG
1
PROG
1