Roger Technology H70/200AC Instrucciones Y Advertencias Para El Instalador página 58

11.1
Acquisition procedure WITH the encoder enabled, WITH or WITHOUT
electric limit switches
TEST
CLOSED
PROG PROG
AP P-
x4 s 1 click
AU to
1
... wait... MOTOR 2
CLOSING
• Press and hold PROG for 4 seconds,
• Press PROG again.
• MOTOR 1 starts opening at normal speed.
• After the delay time set with parameter
•
message
• When the message
delay set with parameter
relative limit switch is reached.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display
mode.
• acquisition error. Press the TEST button to clear the error, and check the safety device in alarm state.
For more information, see chapter 15 "Alarms and faults".
58
TEST
41
No
1 click
Yes
TEST
1 click
00 00
AU to
1
MOTOR 1
OPENING
PARAM. 26
DELAY
2
TIME
... wait...
is shown on the display.
is shown on the display.
, (with a default time setting of 3 s) MOTOR 2 starts an opening manoeuvre.
(default setting 5 s), MOTOR 1 closes until the gate closed mechanical stop or the
A
See chapter 14 and 15
PARAM. 25
DELAY
1
TIME
... wait...
MOTOR 2
OPENING
2
1
MOTOR 1 GATE
CLOSING CLOSED
AU to AU
2
GATE
OPEN
Yes
x2 s
to