Roger Technology H70/200AC Instrucciones Y Advertencias Para El Instalador página 70

Sensing edge NOT INSTALLED.
NC contact (normally closed). The gate reverses only when opening.
Contact with 8k2 resistor. The gate reverses only when opening.
NC contact (normally closed). The gate always reverses.
Contact with 8k2 resistor. The gate always reverses.
Sensing edge NOT INSTALLED.
NC contact (normally closed). The gate reverses only when closing.
Contact with 8k2 resistor. The gate reverses only when closing.
NC contact (normally closed). The gate always reverses.
Contact with 8k2 resistor. The gate always reverses.
N.B.: if no encoder is installed, time based control is used.
then reconnect to mains power.
No encoder installed.
Optical encoders installed (8 pulses/revolution).
E30 Series. Magnetic encoders installed (1 pulse/revolution)
R21 series (version V.1). Magnetic encoders installed (1 pulse/revolution).
STEP MODE.
PARTIAL OPENING
OPENING
CLOSING.
STOP.
Courtesy light. The output COR is managed from the remote control. The light remains lit as long as the
remote control is active. The parameter
Courtesy light ON-OFF (PP). The output COR is managed from the remote control.
The remote control turns the courtesy light on and off. The parameter
FLASHING LIGHT. The FLASHING LIGHT output is managed from the remote control. The light remains
lit as long as the remote control is active. The parameter
FLASHING LIGHT ON-OFF. The FLASHING LIGHT output is managed from the remote control.
The remote control turns the courtesy light on and off. The parameter
Selecting courtesy light mode
Disabled.
ACTIVE. The light remains lit for the entire duration of the manoeuvre.
70
COS1
COS2
is ignored.
is ignored.
is ignored.
is ignored.