Roger Technology H70/200AC Instrucciones Y Advertencias Para El Instalador página 61

11.4
Acquisition procedure WITHOUT encoder and WITHOUT electric or
magnetic limit switch
WARNING: Before starting the self-acquisition procedure:
• set parameters
• set parameter
TEST
CLOSED
PROG
AP P-
x4 s 1 click
PROG
AP 2
MOTOR 1
1 click
OPEN
x2 s
CH 1
2
1
MOTOR 1
CLOSING
• Press and hold PROG for 4 seconds.
• Press PROG again.
• MOTOR 1 starts opening at normal speed.
• After the delay time set with parameter
is shown on the display for 2 s, and is immediately followed by
• When the LEAF 1 reaches the opening mechanical stop, immediately press the PROG key.
• When the LEAF 2 reaches the opening mechanical stop, immediately press the PROG key.
for 2 seconds.
• After this 2 second interval, MOTOR 2 closes automatically. The message
• Press PROG after the required delay period (set automatically with parameter
NOTE: If the parameter is
• The message appears on the display for 2 seconds and is immediately followed by
• When the LEAF 2 reaches the closing mechanical stop, immediately press the PROG key.
• appears on the display.
• When the LEAF 1 reaches the closing mechanical stop, immediately press the PROG key.
If the acquisition procedure is completed successfully, the display enters the command and safety device state display
mode.
• acquisition error. Press the TEST button to clear the error, and check the safety device in alarm state.
For more information, see chapter 15 "Alarms and faults".
and - Deceleration space setting.
TEST
41
No
Sì
TEST
00 00
PROG
AP 1
1
MOTOR 1
OPENING
PROG
MOTOR 2
OPEN 1 click
PROG
CH 2
2
1
MOTOR 2
CLOSE
is shown on the display.
is shown on the display.
(with a default time setting of 3 s), MOTOR 2 starts an opening manoeuvre.
, MOTOR 1 closes at the same time as MOTOR 2.
D
See chapter 14 and 15
1 click
1 click
PARAM. 25
DELAY
1
TIME
... wait...
MOTOR 2
OPENING
x2 s
PA PA
2
1
MOTOR 2
CLOSING
CH 1
CLOSED
1 click
.
x2 s
AP 2 AP 1
2
... wait...
CH 2
DESIRED
DELAY
TIME
PROG
1 click
appears on the display.
appears on the display.
). MOTOR 1 starts to close.
.
PROG
1 click
Yes
61