Roger Technology H70/200AC Instrucciones Y Advertencias Para El Instalador página 71

From 3 to 90 s. The light remains lit for the time period set after the manoeuvre is completed.
From 2 to 9 minutes. The light remains lit for the time period set after the manoeuvre is completed.
When the clock function is active, the gate opens and remains open.
At the end of the programmed time set with the external device (clock), the gate closes.
When the clock function is active, the gate opens and remains open. Any command signal received is
ignored.
When the clock function is active, the gate opens and remains open. Any command signal received is
accepted. When the gate returns to the completely open position, the clock function is reactivated.
Restoring factory default values
NOTE This procedure is only possible is NO data protection password is set.
+
P1
P2
-
Warning!
parameters are suitable for the installation.
The default factory settings may also be restored using the + (PLUS) and/or -
• Turn off the power.
• Press and hold the + (PLUS) and - (MINUS) buttons until the unit switches on.
• The message flashes on the display after 4 s.
• The default factory settings have now been restored.
N.B.
HW version.
Year of manufacture.
Week of manufacture.
Serial number.
FW version.
View manoeuvre counter
The number consists of the values of the parameters from
N.B.
Manoeuvres performed.
Example x100 = 12.300 manoeuvres.
View manoeuvre hour counter
The number consists of the values of the parameters from
N.B.
Manoeuvre hours.
= 123 hours.
View control unit days on counter
The number consists of the values of the parameters from
N.B.
x4 s
to .
to multiplied by 100.
to .
to .
71