Roger Technology CTRL/P Instrucciones Y Advertencias Para El Instalador página 59

CONTACT
27 26(ANT) Antenna connector for slot-in radio receiver board.
29(PED) 28(COM) Partial open command input (NO).
29(PED) 28(COM) The command input (N.C.) available for the connection of the sensor of the ACS/BA/60
30(PP) 28(COM) Step mode command input (NO).
30(PP) 28(COM) The command input (N.C.) available for the connection of the sensor of the ACS/BA/60
31(CH) 28(COM) Close command input (NO).
31(CH) 28(COM) The command input (N.C.) available for the connection of the sensor of the ACS/BA/60
32(AP) 28(COM) Open command input (NO).
32(AP) 28(COM) The command input (N.C.) available for the connection of the sensor of the ACS/BA/60
33(ORO) 34(COM) Clock timer contact input (N.O.).
33(ORO) 34(COM) The command input (N.C.) available for the connection of the sensor of the ACS/BA/60
ENC1
ENC2
LED LIGHT
DESCRIPTION
Use RG58 if an external antenna is used - maximum recommended length: 10 m.
N.B.: do not make joints in cable.
The barrier always opens completely when the contact is closed.
In the case of installations with "Directional" parking mode (parameter
the input PED may be used to receive a closing command from a magnetic loop (NC) (see
chapter 13).
detachable barrier boom coupling system (fig. 8)
When the ACS/BA/60 detachable boom safety system intervenes, the contact switches
from N.C. to N.O.
Enable the contact via parameter
WARNING! Make sure parameter
The function of this command is determined by parameter
detachable barrier boom coupling system (fig. 8)
When the ACS/BA/60 detachable boom safety system intervenes, the contact switches
from N.C. to N.O.
Enable the contact via parameter
detachable barrier boom coupling system (fig. 8)
When the ACS/BA/60 detachable boom safety system intervenes, the contact switches
from N.C. to N.O.
Enable the contact via parameter
WARNING! persistent activation of the opening command prevents automatic reclosure;
the automatic reclosure time count is resumed when the opening command is released.
detachable barrier boom coupling system (fig. 8)
When the ACS/BA/60 detachable boom safety system intervenes, the contact switches
from N.C. to N.O.
Enable the contact via parameter
WARNING! Make sure parameter
When the clock function is active, the barrier opens and remains open.
When the programmed time has elapsed, the barrier closes.
detachable barrier boom coupling system (fig. 8)
When the ACS/BA/60 detachable boom safety system intervenes, the contact switches
from N.C. to N.O.
Enable the contact via parameter
7-way connector for connecting to encoder installed on motor (see fig. 10).
WARNING! Always disconnect from electrical power before disconnecting or connecting
the encoder cable.
6-way connector for connecting to encoder installed on one side of motor (see fig. 10).
WARNING! Always disconnect from electrical power before disconnecting or connecting
the encoder cable.
Connector for connecting B73/EXP signal device and lights installed on top cover (see fig.
10-11).
.
is set to (parking mode disabled)
.
.
.
.
is set to (parking mode disabled)
.
or ),
59