HW version
Year of manufacture
Week of manufacture
Serial number
FW version
View manoeuvre counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Manoeuvres performed
Example:
x100 = 1,234,500 manoeuvres
View manoeuvre hour counter
The number consists of the values of the parameters from
are indicative only.
Manoeuvre hours
Example:
= 123 hours
View control unit days on counter
The number consists of the values of the parameters from
N.B.: The values shown in the table are indicative only.
Days with unit switched on
Example:
= 123 days
Password
Setting a password prevents unauthorised persons from accessing the settings.
With password protection active ( = ), parameters may be viewed but the values CANNOT be modified.
Only a single password is used to control access to the barrier automation system.
WARNING: Contact the Technical Support Service if you lose your password.
Password activation procedure:
• Enter the desired values for parameters
• Use the UP
and/or DOWN
• Press and hold the + and - buttons for 4 seconds.
• The display flashes to confirm that the password has been saved.
• Switch the control unit off and on again. Check that password protection is activated (
Temporary unlock procedure:
• Enter the password.
• Check that
=
.
Password cancellation procedure:
• Enter the password (
=
• Save the values
,
,
• Use the UP
and/or DOWN
• Press and hold the + and - buttons for 4 seconds.
• The display flashes to confirm that the password has been cancelled (the values
and
and indicate that no password is set).
• Switch the control unit off and on again.
Password change protection
Protection deactivated.
Protection activated.
,
,
and
buttons to view parameter
).
,
=
buttons to view parameter
Example:
to
multiplied by 100.
to
. N.B.: The values shown in the table
to
.
.
.
.
,
=
).
,
73