Level 2 Programming (Adjustable Parameters) - Nice RUN400HS Instrucciones Y Advertencias Para La Instalación Y El Uso

7.5 - Level 2 programming (adjustable parameters)

The adjustable parameters are factory set as shown in the Table 8 with: "
procedures, as there is a maximum time interval of 10 seconds between pressing one key and another; otherwise the system exits the procedure automatically
memorising the changes made up to that time .
Entrance led Parameter
L1 Pause Time L1
L2 Step-by-
step
L3 Motor
speed
L4 Open Gate
Indicator
Output
L5 Motor
Force
L6 Partial
open
L7 Mainte-
nance
warning
8
TABLE 8 - Level two functions (adjustable parameters)
Led (level) Value
5 seconds
L2 15 seconds
L3
30 seconds
L4
45 seconds
L5
60 seconds
L6
80 seconds
L7
120 seconds
L8
180 seconds
L1
Open - stop - close - stop
L2
Open - Stop - Close - Open
L3 Open - close - open - close
L4 Apartment block
L5 Apartment block 2 (more than 2" generates stop)
L6 Step-by-Step 2 (less than 2" causes partial opening)
L7 Hold-to-run
L8 "Semi-automatic" opening, "hold-to-run" closing
L1 Very slow
L2 Slow
L3 Medium
L4 Fast
L5 Very fast
L6 Extremely Fast
L7 Opens "Fast"; closes "slow"
L8 Opens "Extremely Fast" Closes "Fast"
L1 Open Gate Indicator Function
L2 On if gate closed
L3 On if gate open
L4 Active with 2nd radio output
L5 Active with 3rd radio output
L6 Active with 4th radio output
L7 Maintenance indicator
L8 Electric lock
L1 Super light gate
L2
"Very light" gate
L3
"Light" gate
L4
"Average" gate
L5
"Average heavy" gate
L6
"Heavy" gate
L7
"Very heavy" gate
L8
"Super heavy" gate
L1
0,5 mt
L2 1 mt
L3 1,5 mt
L4 2 mt
L5 2,5 mt
L6 3 mt
L7 3,4 mt
L8 4 mt
L1 Automatic (depending on the severity of the manoeuvre)
L2 1000
L3 2000
L4 4000
L5 7000
L6 10000
L7 15000
L8 20000
" but can be modified at any time as shown in Table 9 . Take care during modification
Description
Adjusts the pause time, namely the time
which lapses before automatic closure .
Is effective only if automatic closure is
enabled .
Manages the sequence of controls associ-
ated to the Step-by-Step input or to the
1st radio command .
Sets the motor speed during normal travel .
Adjusts the function associated with S .C .A .
output . (whatever the associated function
may be, the output supplies a voltage of
24V –30 +50% with a maximum power of
4W when active) .
The force control system also measures
the ambient temperature, automatically
increasing the force in the event of particu-
larly low temperatures .
Adjusts the measurement of the partial
opening . Partial opening can be controlled
with the 2nd radio command or with
"CLOSE", if the "Close" function is present,
this becomes "Open partially" .
Controls the number of manoeuvres after
which the automation maintenance notifi-
cation signal is sent (see paragraph 8 .2 .3
Maintenance notification).