Spot Measurement - X-Rite PANTONE i1 PRO 3 PLUS Manual De Uso

Spot Measurement

1
3
22
4
To prepare your i1Pro 3 device for spot measurement you need to mount the i1Pro 3
device on the positioning target. Make sure your device is calibrated and the status
indicator is pulsating white before you mount the device. Refer to the user guide of
your measurement software for further details on the spot measurement process.
1. Mount the i1Pro 3 measurement device on the positioning target by inserting the
mounting connector on the positioning target in the mounting interface at the rear
of the i1Pro 3 device.
2. Configure your software to take spot measurements.
3. Position the device on the patch you would like to measure and press the device
down to the positioning target.
4. Press the measurement button on the device. Status indicator light switches off
during a measurement and pulsates green once the measurement has been
successfully finished.
5. To remove the i1Pro 3 device from the positioning target, gently pull the mounting
connector with the positioning target out of the mounting interface at the rear of
the i1Pro 3 device.
EN
23