Wiring The Cords - JUKI DLN-6390 Manual De Instrucciones

2. Wiring the cords
1
4
6
!1
5
2
1
1 CN30 Motor sgnal connector
2 CN38 Operaton panel: Varous knds of sewng can be
programmed. (For detals of the operaton panel
other than CP-8, refer to the Instructon Manual
for the panel to be used.)
3 CN33 Synchronzer : It detects the needle bar pos-
ton.
4 CN37 Presser foot lftng solenod (Only for the auto-
matc presser foot lfter type)
5 CN48 Safety swtch (standard) : When tltng the sew-
ng machne wthout turnng the power OFF, the
operaton of the sewng machne s prohbted so
as to protect aganst danger.
OPTION swtch: Input functon can be changed
by changng over the nternal functon wth ths
swtch.
2
5
3
!2
3
!4
!3 !0 4
7 9
) After set-up of the sewng machne on the table, pass
the cords to the undersde of the table through hole 1
in the table as shown in the figure.
In addton, pass the ar tube whch wll be lad later
through 2 .
2) Insert the top end of earth cord (asm.) 3 and that of
knee swtch (asm.) 4 nto the postons of connector 5
as shown in the figure.
＊ There s no desgnaton of color for the cord of the top
end of knee swtch (asm.) 4 when the nsertng place
s correct.
3) Connect the cords of the sewng machne wth the
cords suppled wth the sewng machne as acces-
sores under the table n accordance wth the wrng
dagram on page , and nsert them nto the connec-
tors located on the nsde of the control box of SC-92.
For the detals, refer to the INSTRUCTION MANUAL
for SC-92.
8
6 CN42 Thread trmmng safety swtch
7 CN39 Standng machne pedal : JUKI standard
PK70, etc. Sewng machne can be controlled
wth external sgnals.
8 CN55 +24 V external power source
9 CN57 Simplified production control counter input
!0 CN36 Machne head solenod: Provded wth solenods
for thread trmmng, reverse feed sttchng, one-
touch type reverse feed swtch.
!1 CN54 Materal end detecton sensor ED-5, etc.
!2 CN5 Optonal functon/devce nput/output.
!3 CN56 Optonal functon/devce output (solenod valve
output).
!4 CN34 Pedal sensor: The pedal sensor suppled wth
the SC-92 s to be connected to ths connec-
tor to operate the sewng machne.
9