Maschio GASPARDO Empleo Y Mantenimiento - Piezas De Repuesto página 65

Code G19503490
USE AND MAINTENANCE
MCM MODULE MAXIMUM TEMPERATURE ALARM
Indicates that the management module of the motor has
reached the maximum temperature.
MAXIMUM ELECTRIC LOAD ALARM
This alarm is shown when the maximum current provided
by the MCM control unit has been exceeded
SEEDING MOTORS
PEED
Indicates that the gear motor does not reach the rotation
speed necessary to distribute the amount required.
DISTRIBUTOR SHAFT ROTATION ALARM
Indicates that the motor is rotating but the doser rotation
sensor is not receiving impulses.
MOTOR ENCODER ALARM
Indicates that the motor does not detect rotation impulses
FAN DRIVE LOW S ALARM
PEED
This alarm is triggered when the fan drive speed is lower
than the minimum limit value set.
This alarm is enabled only during the machine work
phase.
FAN DRIVE HIGH S ALARM
PEED
This alarm is triggered when the fan drive speed is higher
than the maximum limit value set.
This alarm is enabled only during the machine work
phase.
LEVEL 1 SENSOR ALARM
This alarm is triggered when level 1 sensor (placed in the
hopper) does not detect the product.
The alarm is enabled after one of the following events:
After 60 seconds from the previous alarm
advancement speed lower than 0.5 Km/h
once the seed drill has stopped and started
working again
LEVEL 2 SENSOR ALARM
This alarm is triggered when level 2 sensor (placed in the
hopper) does not detect the product.
The alarm is enabled after one of the following events:
After 60 seconds from the previous alarm
advancement speed lower than 0.5 Km/h
once the seed drill has stopped and started working again
Switch off the system and open the
main electric panel to make air circulate.
If the problem persists contact the
After-Sales Centre
Verify that the dosers and/or monitor
rotate freely
MCM module failure
Motor failure
Decrease or increase
advancement speed
Ensure that the dosing roller is
suitable for the type and amount of
product to be distributed
Blocked doser
The doser-axis aluminium coupling
pin is sheared
The doser rotation sensor is faulty,
disconnected or it must be brought closer
Encoder failure
Interrupted encoder connection
Increase the rotation speed of the fan
drive
Ensure that the minimum alarm
threshold is programmed correctly
Decrease the rotation speed of the
fan drive
Ensure that the maximum alarm
threshold is programmed correctly
The product is running out
The product has reached the first
level of product amount
the
EN
- 28