C/O Selection; Pin Change - Maschio GASPARDO Empleo Y Mantenimiento - Piezas De Repuesto

8.1.3 C/O SELECTION

CONFIGURATION
This screen allows defining the machine status (working or out of work) by means of a sensor
or speed threshold.
To modify the parameters:
1) set the parameter required using arrows
2) Use arrows
3) Press OK to save the parameter or ESC to cancel the operation;
Selecting "Area cutout using arrows, one of the following modes can be set using
arrows :
Area cutout speed (Fig. 69): this setting allows using 0.5 Km/h as speed threshold value to
distinguish between work and out of work condition; this setting is used when a machine status
sensor is not present.
cutout speed: indicates the speed threshold under which the tool is considered out of
work;
cutout delay: indicates the time required for the display to detect a speed lower than
the shut-off speed to validate the out of work machine status.
Cutout Sensor (Fig. 70): this setting allows using a status sensor (finger) to indicate the status
of the machine (work and out of work condition).
Two types of statuses can be selected using arrows
"Status = Normal": indicates that when the finger is activated (closed), the monitor
input voltage is null and the tool is in out of work condition;
"Status = Inverted": indicates that when the finger is activated (closed), the monitor
input voltage is null and the tool is in work condition;

8.1.4 PIN CHANGE

CONFIGURATION
This screen allows setting a new safety pin (Fig. 71)
Code G19503490
USE AND MAINTENANCE
SEED DRILL
CONFIGURATION
to modify the parameters
SEED DRILL
CONFIGURATION
C/O SELECTION
;
:
PIN CHANGE
Fig. 69
Fig. 70
Fig. 71
EN
- 33