Troubleshooting Guide - BH FITNESS G-239 Manual De Instrucciones

regularly then you will see your fitness
rating improve.
The test will not work if the sensor is
not connected correctly or if the error
code "E1" appears on the screen.
The TEST will not work if you do not
have both hands placed on the hand-
grip sensors (R) Fig3 after you have
stopped doing the exercise.
If the error code "E1" is shown on the
screen then this means that you do
not have your
correctly on the hand-grip sensors (R).
If the error code "E2" appears on the
screen, this means that you have not
stopped exercising.
FITTING THE ELECTRONIC
MONITOR
FITTING THE HAND-GRIP CABLE
(Pulse sensors)
Take cable (41a-42a) coming out of
the handlebar stem and connect it to
cable (41-42) coming out of the
monitor, Fig 5.
FITTING THE MAIN CABLE
Connect the
coming out of the monitor, Fig 5, to the
terminal block (40) coming out of the
handlebar stem. Remove the screws
(15) from the base of the monitor and
place the monitor on top of the
handlebar ítem (17), making sure not
to catch any of the cables, and attach
it by using the screws removed
previously.

TROUBLESHOOTING GUIDE

Problem: The display comes on but
only the Time function Works.
Solution:
a.-Make sure that the connection
cable is connected.
hands positioned
terminal block
Problem: The display does not come
on or the displayed segments are
very weak.
Solution:
a.-Check that the batteries are fi tted
correctly.
b.-Check the battery charge.
c.- If they are run down change the
batteries.
Problem: Display segments of a
function read-out are not visible or
error
function appear.
Solution:
a.-Remove
seconds and then refit them correctly.
b.-Check the battery charge If they
are run down change the batteries.
c.- If the above steps do not help then
replace the electronic monitor.
(9V Transformer)
Problem: The monitor does not
switch on.
Solution:
a.-Check the 220 V mains connection
b.-Check the output connection from
(34)
the transformer to the monitor.
c.- Check
connections.
d.-Check the cable connections for
the main post..
Avoid leaving the electronic monitor
in direct sunlight as this might
damage the liquid crystal display.
Similarly, do not expose it to water or
knocks.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
15
messages for
the batteries
the monitor
a particular
for 15
cable