Stryker 0502-880-2 Serie Guia Del Usuario página 13

6. After the surgical procedure, disassemble the resectoscope in
reverse order from which it was assembled. Press the
appropriate release button to separate the components of the
resectoscope (see Figure 14).
F F i i g g u u r r e e 1 1 4 4 . . D D i i s s a a s s s s e e m m b b l l i i n n g g t t h h e e r r e e s s e e c c t t o o s s c c o o p p e e
a. releases the inner sheath from the outer sheath
b. releases the working element from the inner sheath
c. releases the electrode from the working element
d. releases the scope from the working element
W W a a r r n n i i n n g g : :
Before every surgical procedure, inspect the resectoscope,
especially the ceramic tip and guiding element, for damage
or cracks. Do not use the device if it shows protrusions or
rough or sharp edges.
Do not reuse single-use monopolar electrodes with the
resectoscope. Physician and patient safety will be
compromised.
To maintain electrical isolation, use only Stryker electrodes
and resectoscope cables.
When urology hardware is used with other applied parts,
total patient current leakage may be additive. Ensure BF
conditions are observed when using the resectoscope with
electromedical devices.
Assembling the Urethrotome
1. Follow steps 1 – 3 of the previous section, "Assembling the
Inner and Outer Sheaths with the Working Element, Scope,
and Electrode," substituting the urethrotome sheath and cold
knives for the resectoscope sheaths and electrode.
2. Follow steps 5 – 6 of the previous section for irrigation tube
connection and disassembly.
7.3 Side Fire Laser Cystoscope System (GreenLight Laser)
Assembling the Scope, Visual Obturator, and Outer Sheath
1. Slide the scope (a) into the obturator (b) until the two pieces
snap together (see Figure 15).
2. Slide the assembly into the outer sheath (c) until the two
pieces snap together.
EN- 13