Tiller Operation - Goodyear GY 1000TL Manual De Instrucciones

English
Owner´s manual
•
Use at a high height
At high altitude, a standard carburetor that mixes
air and fuel will have an excessively rich mixture.
Both fuel efficiency and fuel consumption will
increase.
The performance can be improved at high
altitude by installing a gum of smaller diameter in
the carburetor and regulating the carburetor with
the pilot screw. If you are always going to use the
motor hoist at altitudes above 1,830 m above sea
level, ask your authorized supplier to make these
necessary modifications to the carburetor.
Even with a gum for the right carburetor, the
horsepower of the engine will be reduced
by 3-5% for every 305m (1,000 feet) that the
altitude increases. The altitude affects the engine
power even more if the carburetor has not been
modified.
CAUTION:
The use of the motoazada at lower altitudes for
which the gum is designing will reduce engine
performance, overheat it and can cause serious
damage to the engine since the mixture of air and
fuel is excessive.

4. TILLER OPERATION

1) Motor height adjustment
(For machines without PTO)
CAUTION: Before adjusting the handlebar, place
the motive on a horizontal surface to avoid
accidentally bending the handlebar. To adjust the
height of the motor hoist, loosen the regulator,
select the holes you need and tighten the
regulator.
2) Motor depth adjustment
Place the hitch using a bolt. To regulate the depth
of the motoazada do the following:
Remove the hitch pin and the locking pin, loosen
the fastening screw of the depth control bar
and slide the depth control bar up or down as
necessary.
3) Clutch
The clutch engages and disengages by
transmitting engine power to the transmission.
36
When you tighten the clutch lever a speed is
engaged and the power is transmitted. Squeeze
the handle and the drive will rotate. When you
release the lever, the clutch disengages and the
power stops transmitting, release the clutch lever
and the drive will stop.
CAUTION: Reduce engine revolutions before
using clutch.
(GY1000TL)
(GY6100TL-GY6200DTL)
4) Gear selection
You can put the 2nd gear forward. You must use
the shift lever as shown on the gear plate.
Changing gears:
• Place the throttle lever fully to the right.
• Release the clutch lever to disengage the clutch.
• Put the gear lever in the gear you need.