Goodyear GY 1000TL Manual De Instrucciones página 37

English
Owner´s manual
•
NOTE:
If the gear does not come in, squeeze the
clutch lever and move the hover slightly to
restore the gear.
5) Use of the hitch
(For machines with PTO)
1. Slow march
Squeeze the clutch lever with your left hand to
open the clutch.
Pull the gear lever back with your right hand,
check if it is in the slow position, then hold the
right bar with your right hand (attention: do not
hold the gear bar backwards).
Slowly release the clutch lever to close the
clutch. The machine will move in slow speed.
Accelerate properly with your right hand, the
machine will advance at a maximum speed of 5
km / h.
2. Quick march
Squeeze the clutch lever with your left hand to
open the clutch.
Push the gear lever forward with your right
hand, check if it is in the fast position, then hold
the bar with your right hand (attention: do not
hold the bar back).
Slowly release the clutch bar to close the
clutch. In this situation, the mini cultivator can run
at fast speed.
Accelerate properly with your right hand, the
machine will advance at a maximum speed of 10
km / h.
3. Reverse
Squeeze the clutch lever with your left hand to
open the clutch.
Adjust the shift lever to the neutral position
with your right hand.
Slowly release the clutch lever to close the
clutch, the machine will reverse (attention: do not
unlock the recoil bar).
If it is not necessary to reverse, you must slowly
hold the clutch lever slowly with your left hand,
then unlock the gear bar with your right hand.
4. For any gearshift you should slow down (The
standard should be the continuous work of the
diesel engine), then close the clutch, until the
machine stops working.
5. When changing the address, The handlebar
should be left or right (attention: do not hold the
handlebar badly, to avoid damaging the steering
wheels).
6. Stop working
Hold the clutch lever with your left hand to
open the clutch.
After adjusting the shift lever to the neutral
position, you must unlock the clutch lever so that
the machine stops working.
When it is necessary to stop working, the
procedure must be carried out in accordance with
the instructions of the diesel engine (attention:
this work is usually done on smooth ground).
6) Use attachments with PTO
* According to models
1. To use the implements you must remove the
wheels, fix the hexagonal sleeve of the implement
on both sides of the hexagonal axle with M8 ×
55 bolts. Attention: there are blade units on both
sides; make sure the blade edge is oriented first.
After installing the rotating blades, you must
install the safety panel to avoid knife injuries. The
working depth can be adjusted by adjusting the
resistance bar.
2. When trenching, you must disassemble the
resistance bar, install the trencher and adjust its
depth and height. After finishing these settings,
you can start the job
Width Range: 14cm-40cm
Depth Range: 11cm-25cm
3.Multifunctional work
37