Stopping The Engine - Goodyear GY 1000TL Manual De Instrucciones

English
Owner´s manual
•
Loosen the locking lever, turn the handlebar
180 °, place the auxiliary shift in the "L" position.
Connect the implement to be used (reaper, rotary
cultivator, lawn mower, lawn mower, fumigation
pump, etc.) to the rear cover of the gearbox,
in the power take-off, screw the nuts of the 4
screws. Place the shift lever in the neutral position
"0", place the auxiliary shift lever in the low
speed position "L", use the rear shift lever to start
working with the implements.
7) Driving tricks
Set the handlebar to the height that is
comfortable for you (waist height is usually
recommended).
If the machine pulls forward while working, push
down the handlebar; If the machine does not
move forward, move the handlebar from side to
side.
Turns: The best way to make a turn is to lower the
handlebar to make the center of gravity of the
motor hover travel back and then make the turn.
This will allow you to rotate with relative ease.
8) Normal operating angle
Lower the handlebar slightly so that the front of
the machine rises between 6-8º.
To get the most out of the motoazada, try to keep
the motoazada at the angle shown while you are
working the earth.
38
CAUTION:
• Do not use the motor hoe with a rotor with a
diameter greater than 300mm.
• Working with the motoazada on slopes can
cause the motoazada to tip over.
• Letting anyone use the motoazada without the
necessary training can end up in an accident
with injuries.
• Wear safety shoes cover his entire foot.
Working with the motoazada with bare feet or
with open shoes or with sandals will increase
the likelihood of damage.
• Do not use the motoazada at night.
• Be sure to transport the chainsaw from one site
to another with the help of another person if you
do not have a carrier.
• When the rotor is blinded with mud, stones, etc .;
Stop the engine immediately and clean the rotor
in a safe place. Be sure to wear thick gloves when
cleaning the rotor.
To prevent damage, check that the motor has
no sign of damage or any other failure. Inspect it
every time you use it and after each use.

5. STOPPING THE ENGINE

In an emergency situation:
Set the engine switch to "OFF".
Under normal conditions.
1) Release the clutch lever to DISENGAR and put
the shift lever in neutral.
Motor switch
OFF