Advanced Functionnalities Of Digiwave Ii; Mig-Mag Welding Cycle Advanced Setting - Air Liquide SAF-FRO DIGIWAVE II 420 Manual Del Usuario

4 – ADVANCED FUNCTIONNALITIES OF DIGIWAVE II

4.1. MIG-MAG WELDING CYCLE ADVANCED SETTING

MIG-MAG WELDING CYCLE SETTING
The MIG welding cycle setting menu
1. Pregas
2. Hotstart
3. Welding step
4. Crater filler
5. Burn back
6. Affûtage fil
7. Postgas
the voltage is present at the end of the wire from the slow wire forwarding phase to the post retract spray phase.
16
distinguishes 7 phases on the welding cycle:
1 List of the phases of the cycle
2 Selected cycle phase
3 Parameters table of the selected cycle phase.
Use the left encoder to scroll the settings.
Use the right encoder to adjust the selected parameter
4
Switch the cursor between cycle phase selection and parameter table.
Also possible with the OK and ESC buttons
1. Pregas
Gas timing before the welding cycle starts
2. Hotstart/Softstart
In the hotstart phase, a wire speed greater than the welding phase wire speed allows
quicker penetration on start-up. Otherwise, the hotstart phase allows a low start-up with
a progressive ramp up of wire speed.
WARNING
Variables : T(s) [0.0 ; 10.0]
Variables : T(s) [0.0 ; 10.0]
DIGIWAVE II