Air Liquide SAF-FRO DIGIWAVE II 420 Manual Del Usuario página 19

FULL MIG-MAG WELDING CYCLE
STRIKING ADJUSTMENT
The striking adjustment is accessible in the menu SETUP of the MIG page.
Note: the striking is the 2 phase of the welding cycle.
The striking of every synergy is by default optimal in most of the application cases. However, in few very specific application cases, the user may want to
modify the striking characteristics.
Tuning parameters of striking:
K = Variable coefficient de -10 / 0 / +10
Name of the parameter
Striking low wire advance K
Striking current K
Striking transition energy K
WARNING
The user is responsible for the eventual dysfunction which a modification of the striking parameters may cause.
DIGIWAVE II
1 Pre-gas
2 Slow wire inch [forward]
3 Hotstart
4 Welding phase
5 Crater filler
6 Burnback
6 Affûtage fil
7 Post-gas
Allows modifying the low wire advance before striking.
Allows tuning the striking current energy.
Allows tuning the arc energy during the transit between the arc striking and the first
regime of the welding cycle.
Description
19