User Management - Air Liquide SAF-FRO DIGIWAVE II 420 Manual Del Usuario

The level of rights available are the following, in decreasing order:
1. Administrator
2. Technician
3. Welder
To be allowed to access to a function of the power source, the user must have a level higher or equad level of rights superior or equal to the level of rights
access associated to the function.
The access right of every function can be consulted and modified in the management page:
Configuration > User management > Right Management
List of the functions which the profiles modify for the access rights:
Name of the access right
Program limitation
Process control
User synergy
Striking adjustment
Program list activation
MIG 4T Program list activation
Program management
Program selection
Traceability
Configuration
Maintenance
Setup
Calibration

User management

User management:
The first user profile must be a profile Administrator with a password. The profiles Technician and Welder are unaccessible when the first profile has not
been created. A welder profile can be created without a password, it then becomes the default user if no idenfitication is done.
keep your Administrator's password carefully.
Lost password? Please contact your reseller or the After Sales Services.
USER IDENTIFICATION
From the home page, the button «
User identification:
- Allow or deny access to the different functions of the power source depending on the profile.
- Set down in the generated trace files the name of the identified user.
To be identified as a user, select the desired user, validate and write your password if needed
Modify user's password
Log out the current session
Create a user profile from the profile associated with the USB key. The insertion of the USB key causes automatic user's identification.
The USB key can be disconnected without logging out.
DO NOT leave the USB key connected to the power source during its use because of risk of deterioration.
DIGIWAVE II
Limitations
Control Process tuning
Access to the user synergies menu
Striking tuning
Access to the program list page
Access to the MIG 4T program list
Access to the program management page
Select the welding program
Access to the traceability menu
Access to the configuration menu
Access to the maintenance menu
Access to the MIG SETUP menu
Harness calibration
Access to the users management page
» allows access of the user identification page. If there is no created user, this page is not available.
Description
WARNING
WARNING
Default level of access right
Technician
Technician
Technician
Technician
Technician
Technician
Technician
Welder
Technician
Technician
Administrator
Welder
Welder
Administrator
27