Air Liquide SAF-FRO DIGIWAVE II 420 Manual Del Usuario página 25

List management
See below useful icons for list management.
Action icons
Add / Suppress
/
The positioning order of a program in a list will be the chaining order from the welding tuning page.
Activation
When a program list is activated
top left corner of this page. The programs are chained in the same order as they were added into the list. It is not possible to create a program while a list is
activated.
If one of the programs of a list is masked or supressed, the list cannot be activated anymore.
The program lists are made for out of welding chaining. You can activate the program call out of welding in the menu: Configuration > Installation > Cycle.
DIGIWAVE II
1 Program lists set into the power source
2 Number of the list
3 Program Lists
4 Name of the list
5 Welding programs contained into the list
6 Activate or desactivate a list
7 Add a new list
8 Suppress an existing list
Program List
Activation / Deactivation
/
, you can only select the programs of this list from the welding tuning page and the program list icon appears in the
MIG 4T Program List Program
Preview Edition
25