Spare Parts; Fault List Description - Air Liquide SAF-FRO DIGIWAVE II 420 Manual Del Usuario

9.4. SPARE PARTS

9.5. FAULT LIST DESCRIPTION

The listed faults here after can be fixed by following the indications with caution. If a displayed fault doesn't belong to this list below, please contact the
after sales services.
Servicing of electrical equipment must be performed by qualified personnel only.
Exceeding the maximum power allowed by the power supply
DISPLAY OF THE MESSAGE E07 "Power supply over voltage" or "Power supply under voltage"
Overvoltage or undervoltage phase supply network of the power source
( 400V Tolerance - 3 ~ 15 % / - 20%)
Exceeding the authorized power source
Exceeding the authorized power source
DIGIWAVE II
Rep. / Item 420
W000371924
1 W000374093
2 W000277894
3 W000374006
4 W000374008
5 W000374119
6 W000277882
7 W000277883
W000148736
9 W000371935
10 W000277887
11 W000277888
12 W000148911
13 W000370473
14 W000370460
15 W000374003
16 W000374005
15/16 W000374004
17 W000277912
W000277891
1 W000277910
18 W000373702
19 W000373703
Any intervention requiring the opening of the casing of the generator or one of its peripherals must be
exclusively made by an agent appointed or authorized by Air Liquide Welding.
CAUSES
DISPLAY OF THE MESSAGE E03 « Exceeded max
DISPLAY OF THE MESSAGE E15 « Maximum current average Overflow»
DISPLAY OF THE MESSAGE E16 « Exceeding maximum current boot»
520
W000371927
W000374093 Front panel sub-assembly
Internal Components
W000277894 Jumper cable + Trim Trio harness
plug
W000374006 Bretelle et prise automatique
W000374008 Bretelle et prise auxiliaire
W000374119 Cycle control card
W000277882 Auxiliary power supply card
W000277883 Inverter power supply card
W000148736 Fuse kit
W000373607 Inverter
W000373609 Inverter fan
W000277888 ON/OFF Switch
W000148911 Power terminal kit
W000370473 Primary filter card
W000370460 Secondary filter card
W000374003 USB jumper
W000374005 Ethernet cable
W000374004 Ethernet/USB plug cap
External Components
W000277912 Front/ rear plastic fittings kit
W000277891 Plug kit
W000277910 Protective plastic hood
W000373702 Filter support
W000373703 Filter
WARNING:
Check that the parameters of welding program do not exceed the
characteristics of the current source ( mode including free )
Check network characteristics
Check the program settings welding do not exceed the characteristics of
the current source ( including Free mode) maximum average current
Check the program settings welding do not exceed the characteristics of
the current source ( including Free mode) maximum instantaneous current
Désignation
SOLUTIONS
»
42