Chinstrap With Micro-Lock Ratchet Fastener 62 H - SCHUBERTH C3 pro Manual De Usuario

C. THE HELMET
CLOSING THE CHIN BAR
To close the chin bar, pivot it down with
one hand until both locks audibly engage.
Note:
Each time you close the chin bar, check that the locks have engaged
properly by pressing the chin bar upwards.
Tip:
When using the additional adjustable wind deflector, locking the chin
bar is easier if you grip the chin pad underneath with a finger of your
other hand to help you ease the chin bar over your chin.
Caution:
Never ride with the chin bar raised.
10. CHINSTRAP WITH MICRO-LOCK
RATCHET FASTENERS
The C3 PRO comes with a ratchet fastener.
This locking system is easy to use and
enables you to adjust the chinstrap
perfectly to your head every
time you put the helmet on.
62
ADJUSTING THE CHINSTRAP
The length of the chinstrap is adjusted by increasing or reducing the length
of strap pulled through the metal buckles. Adjust the length of the chinstrap
so that it fits firmly but comfortably under your chin and fix the end of the
strap using the retaining loop with comfort pad.
Caution:
When adjusting the strap, make sure that the helmet cannot be
pulled off in a forward direction with the chinstrap closed.
Caution:
Check the adjustment of the chinstrap length at regular intervals.
Opening and closing
To close the chinstrap fastener, slide the ratchet tongue step by step into the
locking buckle. If you find that the chinstrap fits too loosely around your chin,
slide the ratchet tongue one step further into the locking buckle.
When adjusting the chinstrap, make sure that it rests firmly but not uncom-
fortably around your chin. To open the chinstrap, pull the red ribbon on the
ratchet fastener upwards to release the locking buckle. Then pull the ratchet
tongue out of the locking buckle.
EN
63