SCHUBERTH C3 pro Manual De Usuario página 41

C. THE HELMET
3. Zip up the zipper.
4. Mount the cheek pad using the three
pins on the red plugs and sockets.
Ensure that the head strap
cushion's plastic strap with the round
holes is inserted over the rear cheek
cushion pin.
5. Repeat points 1 to 4 to mount the
cheek pad on the other side.
6. Reinsert the neck collar by first
inserting the guide pins into the front
plugs and sockets on the lower helmet
edge on both sides and then mount the
neck collar into the guide gap piece by
piece.
78
Note:
Ensure that the A.R.O.S. straps are not twisted.
Note:
When inserting the crown liner, make sure that the headband ventilation
cut-outs are positioned over the ventilation channels at the back of
the helmet and that the crown liner runs centrally between the two
ventilation channels.
Caution:
Never ride when parts of the inner lining have been removed.
Caution:
Excessive heat (e.g. exhaust heat) can cause damage to the inner
lining!
Note:
To avoid damage to the inner lining and inner shell, do not hang the
helmet over the mirrors or handlebar grips.
Note:
When replacing the cheek pads,
the Anti-Roll-Off System must be
properly joined to the chinstrap.
For this purpose, the loops on the
free ends of the A.R.O.S. straps –
as shown in the illustration below –
must enclose the corresponding
ends of the chinstrap and the A.R.O.S.
straps must not be twisted or knotted.
Note:
For size 54/55 helmets, also ensure
that the A.R.O.S. straps are always
threaded through the additional
loops in the back of the neck area.
EN
79