Troubleshooting - Kichler VASSAR Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING

Problem
Solution
Fan will not start.
1. Check circuit fuses or breakers.
2. Check all electrical connections to insure proper contact.
CAUTION: Make sure the main power is OFF when checking any electrical connection.
3.
Make sure transmitter batteries are installed properly, and ensure the batteries have a good charge.
Fan sounds noisy.
1. Make sure all motor housing screws are snug.
2. Make sure the screws that attach the fan blade brackets to the motor are tight.
3. Make sure wire nut connections are not rubbing against each other or the interior wall of the switch housing.
CAUTION: Make sure main power is off.
4. Allow a 24-hour "breaking-in" period. Most noise associated with a new fan disappear during this time.
5. If using an optional light kit, make sure the screws securing the glassware are tight. Make sure the light bulbs are not touching
any other component.
6. Do not connect this fan to wall mounted variable speed control(s). they are not compatible with ceiling fan motors or
remote controls.
7. Make sure the upper canopy is a short distance from the ceiling. It should not touch the ceiling.
1. Check that all blade and blade arm screws are secure.
Fan wobble.
2. Most fan wobbling problems are caused when blade levels are unequal. Check this level by selecting a point on the
ceiling above the tip of one of the blades. Measure this distance. Rotate the fan until the next blade is positioned for
measurement. Repeat for each blade. The distance deviation should be equal within 1/8".
3.
Use the enclosed Blade Balancing Kit if the blade wobble is still noticeable.
4. If the blade wobble is still noticeable, interchanging two adjacent (side by side) blades can redistribute the weight and
possibly result in smoother operation.
Remote control
1.
Ceiling Fans with remote control systems CAN NOT be operated in conjunction with any other control system EXCEPT a basic
malfunction.
On/Off wall switch, if desired.
2.
Make sure the frequency dip switches in the transmitter and receiver have identical settings.
3.
Make sure the Black Antenna on the receiver is NOT tangled with any other electrical wires and is extended around the inside
of the ceiling canopy.
52" VASSAR
LED | 19
TM

Publicidad

Tabla de contenido
loading

Tabla de contenido