Electrical Connections - Kichler VASSAR Manual De Instrucciones

ELECTRICAL CONNECTIONS

WARNING: To avoid possible electrical shock, be sure you have turned
off the power at the main circuit panel.
Follow the steps below to connect the fan to your household wiring.
Use the wire connecting nuts suppled with your fan. Secure the
connectors with electrical tape. Make sure there are no loose wire
strands or connections.
NOTE: The CoolTouch™ Control System is equipped with 16 possible
frequency combinations to prevent interference from or with other
remote control units. The frequency switches on your receiver and
transmitter have been preset at the factory. Please recheck to make
sure the switches on transmitter and receiver are set to the same
position, any combination of settings will operate the fan as long as the
transmitter and receiver are set to the same position. (Fig. 12)
Step 1. Insert the receiver into the ceiling mounting bracket with the
flat side of the receiver facing the ceiling. (Fig. 13) For best
performance, make sure the Black Antenna, on the end of the
receiver, remains extended and not tangled with any of the electrical
wires.
Code switch
ON
HI
ON ECE
LIGHT
MED
1 2 3 4
LOW
ON ECE
FAN OFF
1 2 3 4
Fig. 12
Receiver
Fig. 13
52" VASSAR
Hanger
bracket
LED | 11
TM