HANGING THE FAN
Step 5. Remove the hanger ball from the downrod assembly by
loosening the set screw, unscrewing and removing removing the cross
pin and unscrewing the ball off the rod. (Fig. 7)
Step 6. Loosen the two set screws and remove the hitch pin and
retaining clip from the coupling on top of the motor assembly. (Fig. 8)
Step 7. Carefully feed the electrical lead wires from the fan up
through the downrod. Thread the downrod into the coupling until the
Hitch pin holes are aligned.
Next, replace the hitch pin and retaining clip. Tighten both set screws.
(Fig. 8)
8 | KICHLER.COM
(continued)
Hanger
ball
Supply wires
Retaining clip
Cross pin
Set screw
Downrod
Fig. 7
Downrod
Set screws
Set screws
Hitch pin
Fig. 8