2-Target Mode; Measurement With Wheels Raised - Corghi EXACT LINEAR PLUS Manual De Uso

The following procedure allows you to align just the front axle of the vehicle. It is recommended for
caravans or vans for which it is not possible to mount the brackets and targets on the rear axle, due
to the fairing of the vehicle.
1) Mount only the front 2 target and clamps.
These new icons are shown if the automatic tracking is active.
2) Select the mode ROC and continue.
3) Make the steering.
4) Adjust the front axle.
5) If necessary, make the second steering.
6) Adjust the front axle.
7) The procedure is terminated on the Print page.
NOTE: the measurement in 2-target mode does not guarantee that the steering wheel is perfectly
straight, as the rear axle reference is not calculated.

MEASUREMENT WITH WHEELS RAISED

The "Measurement with wheel raised" procedure allows the vehicle to be adjusted with two or four
wheels lifted off the ground.
Working in this position prevents the weight of the vehicle applying force to the adjustment regis-
ters, preventing their use.
From an axle (front or rear) adjustment screen, activate the procedure by selecting
values measured are frozen and will not change.
Operator's manual EXACT LINEAR

2-TARGET MODE

Select the procedure with single axle.
Single axle measurement active.
To return to the 4-target mode, press the key
again.
The 4-target mode is restored in any case at
the end of the work.
EN
; the
71