Qlogic QME8242 Guia Del Usuario página 112

iSCSI Configuration Using Fast!UTIL: QLogic QME8242 Mezzanine Card User's Guide
c. On the Select LUN window, select the LUN to set the target as the primary iSCSI boot device.
6. Press the <Esc> key, and then select Save changes.
7. Press <Esc> again, and then select Reboot System.
After rebooting, the iSCSI BIOS loads for the target configured previously in the QLogic iSCSI Fast!UTIL BIOS utility.
8. During POST, press the <F2> key to enter the Dell system BIOS as shown in
Figure 6: Dell System BIOS
a. Select Boot Settings.
b. Select Hard-Disk Drive Sequence, and then move the iSCSI target to the first position.
c. Select Boot Sequence, and then move the iSCSI target to the first position.
9. Select Save changes and exit.
10. Follow the manufacturer's OS installation instructions.
Transferring the OS Image to the iSCSI Target
QLogic iSCSI boot does not require transferring the OS image to the iSCSI target.
file:///T|/htdocs/NETWORK/QLogic/71922/en/fastutil.htm[9/26/2012 4:26:21 PM]
All manuals and user guides at all-guides.com
Figure 6.